EasyManuals Logo

COBHAM 2201R Reference Guide

COBHAM 2201R
295 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #74 background imageLoading...
Page #74 background image
2201R Mobile Tester SCPI Reference Guide
Chapter 6 Status commands
47090/323
Copyright © 2016 Aeroflex Limited. All rights reserved.
74
:STATus:OPERation:SIGNalling:EGPRs:CONDition?
Syntax
:STATus:OPERation:SIGNalling:EGPRs:CONDition?
Parameters
There are no parameters.
Description
This command reads out the current contents of the GPRS Signaling Operation Condition Register. This register
reflects the current state of the 2201R in terms of signaling and is updated continuously.
Note This register is non-destructive. This means that it keeps its contents after any query.
Query
There is only a query form of this command available. The query returns a string containing one integer. The integer
express all bits set in the 16 bit signaling operation condition register.
Note:
See :STATus:OPERation:SIGNalling:EGPRs[:EVENt] for the meaning of the individual bits of the register.
Example
:STATus:OPERation:SIGNalling:EGPRs:CONDition?
Value returned in this example: "3".
This means that bits 0 and 1 have been set.
:STATus:OPERation:SIGNalling:EGPRs:ENABLe
Syntax
:STATus:OPERation:SIGNalling:EGPRs:ENABLe <int1>
Parameters
int1 is an integer. The minimum value for int1 is 0, the maximum value is 32767. The value default is 0.
Description
This command sets the Enable filter of the GPRS Signaling Operation Register Group. This mask is ANDed with the
GPRS signaling operation event register and thus decides what kind of events are forwarded to bit 10 of the General
Operation Register Group.
See :STATus:OPERation:SIGNalling:EGPRs[:EVENt] for the meaning of the individual bits of the register.
Query
There is no query form of this command available.
Example
:STATus:OPERation:SIGNalling:EGPRs:ENABle 4
This means that any setting of bit 2 (PDTCH set up, ready for measurements) of the GPRS signaling operation event
register raises bit 10 of the general operation condition register.

Table of Contents

Other manuals for COBHAM 2201R

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the COBHAM 2201R and is the answer not in the manual?

COBHAM 2201R Specifications

General IconGeneral
BrandCOBHAM
Model2201R
CategoryTest Equipment
LanguageEnglish