2201R Mobile Tester SCPI Reference Guide
Chapter 8 Configuration commands
47090/323
Copyright © 2016 Aeroflex Limited. All rights reserved.
162
:CONFigure:EGPRs:BLER:PDUCount
Syntax
:CONFigure:EGPRs:BLER:PDUCount <int1>
Parameters
int1 is an integer parameter.
The minimum value for int1 is 0, the maximum value is 4095. The default value for int1 is 4095.
Description
Defines the number of PDUs as defined in ETSI TS 101 293 / 8.13. Applies to BLER measurements in GPRS
synchronous mode.
Query
The query form of this command returns the current setting. The string delivered back contains one integer.
Example
:CONFigure:EGPRs:BLER:PDUCount 1000
:CONF:EGPRs:BLER:PDUCount?
Value returned: "1000"
To Next Page
Loading...
Need help?
General