2201R Mobile Tester SCPI Reference Guide
Chapter 8 Configuration commands
47090/323
Copyright © 2016 Aeroflex Limited. All rights reserved.
118
:CONFigure:GPRS:BS:BCH:ARFCn
Syntax
:CONFigure:GPRS:BS:BCH:ARFCn <int1>
Parameters
int1 is an integer.
The minimum value for int1 is 0, the maximum value is 1023. The default value for int1 is 63.
Description
This command sets the channel number for the base channel (BCCH).
Note: The base channel is sometimes also referred to as the channel number of the main carrier.
Query
The query form of this command returns the current setting. The string delivered back contains one integer.
Example
:CONFigure:GPRS:BS:BCH:ARFCn 60
:CONF:GPRS:BS:BCH:ARFC?
Value returned: "60".
:CONFigure:GPRS:BS:CBA
Syntax
:CONFigure:GPRS:BS:CBA <int1>
Parameters
int1 is an integer.
The minimum value for int1 is 0, the maximum value is 1. The default value for int1 is 0.
Description
This command sets the cell barred access parameter.
A 0 set for the CBA allows the mobile to contact the base station, while a 1 blocks the base station and the mobile
under test is not granted access.
Query
The query form of this command returns the current setting. The string delivered back contains one integer.
Example
:CONFigure:GPRS:BS:CBA 1
:CONF:GPRS:BS:CBA?
Value returned: "1".
To Next Page
Loading...
Need help?
General