2201R Mobile Tester SCPI Reference Guide
Chapter 8 Configuration commands
47090/323
Copyright © 2016 Aeroflex Limited. All rights reserved.
84
Introduction
This subsystem incorporates all changeable network parameters of all systems implemented. The key commands are
as follows:
CONFigure:CSYStem Selects the communications system to
work with.
CONFigure:<SystemOption>:... These commands select parameters
within a communications system.
CONFigure:<SystemOption>:BS:...
or
CONFigure:<SystemOption>
:NB:...
These are the commands to set specific
system parameters like the base station's
RF output power level or its identity.
CONFigure:<SystemOption> :MSTAtion:...
or
CONFigure:<SystemOption> :UE:...
The mobile-specific information is
handed over to the 2201R using these
commands. One example is the power
level.
CONFigure:<SystemOption>:...
:GROup:...
With the help of these commands, groups
of measurements may be defined.
CONFigure:COUPloss:... These commands provide access to the
coupling loss compensation feature of the
2201R.
NOTE
Always select the communication system via the :Configure:CSYStem
command first before you change any parameters using different SCPI commands.
To Next Page
Loading...
Need help?
General