2201R Mobile Tester SCPI Reference Guide
Chapter 8 Configuration commands
47090/323
Copyright © 2016 Aeroflex Limited. All rights reserved.
90
:CONFigure:GSM:ASSAll
Syntax
:CONFigure:GSM:ASSAll <int1>,<int2>
Parameters
int1 and int2 are two integers.
The minimum value for int1 is 0, the maximum value is 1023. The default value for int1 is 45.
The minimum value for int2 is 0, the maximum value is 31. The default value for int2 is 10.
Description
This command changes the TCH (traffic channel) number and the power control level in one assignment.
int1 is the new TCH channel number and int2 is the MS power control level.
Note: The RF power control level is a code. The corresponding RF output power of the mobile under test depends on
the type of GSM system and the frequency range.
Query
The query form of this command returns the current setting. The string delivered back contains two integers. The first
one expresses the TCH number and the second one the MS power control level.
Example
:CONFigure:GSM:ASSAll 45,10
:CONF:GSM:ASA?
Value returned: "45,10".
:CONFigure:GSM:BS:LEVel
Syntax
:CONFigure:GSM:BS:LEVel <real1>
Parameters
real1 is a floating point real number.
The minimum value for real1 is -110.0, the maximum value -20.0, but this depends on the chosen coupling loss
values. The minimum resolution possible for real1 is 0.1. The default value for real1 is -60.0.
Description
This command sets the RF output power level of the 2201R (i.e. the simulated base station). The physical dimension
of real1 is dBm.
Query
The query form of this command returns the current RF output power setting of the 2201R. The string delivered back
contains one real number.
Example
:CONFigure:GSM:BS:LEVel -50.5
:CONF:GSM:BS:LEV?
Value returned: "-50.5".
To Next Page
Loading...
Need help?
General