2201R Mobile Tester SCPI Reference Guide
Chapter 9 Call commands
47090/323
Copyright © 2016 Aeroflex Limited. All rights reserved.
164
Introduction
This subsystem contains commands
• for call setup and handling procedures.
• to read out the measurement report generated by the mobile.
• to read out the mobile’s ID and further mobile parameters.
GSM commands
:CALL:GSM:BSORiginate
Syntax
:CALL:GSM:BSOR[<String1>][,<String2>]
Parameters
String1 is the optional parameter. It contains the Calling Party BCD Number.
String2 is an optional parameter. It defines the Called Party Sub-address information.
Description
Initiates a call-setup by the base station (the 2201R).
Query
There is no query form of this command available.
Example
:CALL:GSM:BSOR "25478955"
This originates a BS-originated Call with Calling Party BCD Number "25478955".
:CALL:GSM:BSOR "2548955","08"
This initiates a BS-originated Call with Calling Party BCD Number "25478955" and Sub-address "08".
:CALL:GSM:BSRelease
Syntax
:CALL:GSM:BSRelease
Parameters
There are no parameters.
Description
This command makes the 2201R terminate the ongoing call.
Query
There is no query form of this command available.
Example
:CALL:GSM:BSR
This command releases the call.
To Next Page
Loading...
Need help?
General