To Next Page

To Previous Page

2201R Mobile Tester SCPI Reference Guide

Chapter 8 Configuration commands

47090/323

157

:CONFigure:EGPRs:MSTAtion:MSLot

Syntax

:CONFigure:EGPRs:MSTAtion:MSLot <int1>

Parameters

int1 is an integer.

The minimum value for int1 is 1, the maximum value is 4. The default value for int1 is 2.

Description

This command either sets the number of UL time slots that the mobile under test is commanded to use during

multislot testing.

Query

The query form of this command returns the current setting. The string delivered back contains one integer.

Example

:CONFigure:EGPRs:MSTAtion:MSLot 4

:CONF:EGPRs:MSTA:MSL?

Value returned in this example: "4".

:CONFigure:EGPRs:MSTAtion:LOOPback

Syntax

:CONFigure:EGPRs:MSTAtion:LOOPback <PredefExp>

Parameters

PredefExp is one of the following predefined expressions: ON|OFF. Default is ON.

Description

Selects the loopback mode. If the parameter PredefExp is set to ON, the mobile station supports GPRS loopback

(mode B), if the parameter PredefExp is set to OFF, the mobile station does not support GPRS loopback (mode A).

Query

The query form of this command returns the current setting. The string delivered back contains one of the predefined

expressions as explained above.

Example

:CONFigure:EGPRs:MSTAtion:LOOPback ON

:CONF:EGPRs:MSTA:LOOP?

Value returned in this example: "ON".

COBHAM 2201R Reference Guide

Other manuals for COBHAM 2201R