To Next Page

To Previous Page

2201R Mobile Tester SCPI Reference Guide

Chapter 3 Introduction to the SCPI command reference

47090/323

SCPI command reference structure

The following chapters contain lists of SCPI commands and queries. Each command is described with its valid input

and output formats. There is a chapter for each subsystem.

Command response on USB, RS-232 and TCP/IP

Every command sent to the 2201R is answered by the terminator string as set with the respective command:

• TCP/IP: :SYSTem:COMMunicate:TCP:TERMinator <CRLF|LF|CR>

• RS232: :SYSTem:COMMunicate:SERA:TERMinator <CRLF|LF|CR>

• USB: :SYSTem:COMMunicate:SERB:TERMinator <CRLF|LF|CR>

Bluetooth commands

The SCPI commands for the 4489 Bluetooth Connectivity Test Package can be found in the Bluetooth Connectivity

Test Products User Guide.

Signaling operation register group

This group of registers is 16 bits wide. Its main task is to deal with events related to the signaling status. The signaling

operations depend on the system option and can be found in the :STATus:OPERation:SIGNalling group of commands

(see the respective EVENt command for the signaling system at hand).

The Result bit of this group of registers is forwarded to bit 8 of the general operation register group.

COBHAM 2201R Reference Guide

Other manuals for COBHAM 2201R