COBHAM 2201R - Introduction; Status Commands; Status:preset

2201R Mobile Tester SCPI Reference Guide
Chapter 6 Status commands
47090/323
Copyright © 2016 Aeroflex Limited. All rights reserved.
63
Introduction
The STATus subsystem offers commands to read out and deal with the general operation register group and its
subordinate groups of registers.
Please see section ’The STATus subsystem’ on page25 for more details, including the meaning of the status register
bits.
STATus commands
:STATus:PRESet
Syntax
:STATus:PRESet
Parameters
There are no parameters.
Description
This command sets all user-definable settings of the status subsystem to their factory default values. The default
values for the single commands are explained below.
Query
There is no query form of this command available.
Example
:STATus:PRESet
Resets all parameters of the status subsystem to their default values as listed below.
NOTE
The commands to deal with the event status register group and the service register are
part of the SCPI command errors.