To Next Page

To Previous Page

2201R Mobile Tester SCPI Reference Guide

Chapter 8 Configuration commands

47090/323

155

:CONFigure:EGPRs:MSTAtion:DRX

Syntax

:CONFigure:EGPRs:MSTAtion:DRX <int1>

Parameters

int1 is an integer.

The minimum value for int1 is 0, the maximum value is 7. The default value for int1 is 0.

Description

This command sets the BS-PA-MFRMS parameter, broadcast in the control channel description information element.

This parameter is used for discontinuous reception (DRX).

Note: The value entered here is coded according to the following scheme: the number of multiframes used is the

number entered here plus 2. This means that the default value (0) leads to a DRX period of two multiframes.

Query

The query form of this command returns the current setting. The string delivered back contains one integer.

Example

:CONFigure:EGPRs:MSTAtion:DRX 2

:CONF:EGPRs:MSTA:DRX?

Value returned in this example: "2", resulting in a DRX period of four multiframes.

:CONFigure:EGPRs:MSTAtion:TADVance

Syntax

:CONFigure:EGPRs:MSTAtion:TADVance <int1>

Parameters

int1 is an integer.

The minimum value for int1 is 0, the maximum value is 63. The default value for int1 is 0.

Description

This command sets the timing advance for the mobile under test to use. The current setting of the timing advance is

broadcast to the mobile in the SACCH physical header.

Query

The query form of this command returns the current setting. The string delivered back contains one integer.

Example

:CONFigure:EGPRs:MSTAtion:TADVance 12

:CONF:EGPRs:MSTA:TADV?

Value returned in this example: "12".

COBHAM 2201R Reference Guide

Other manuals for COBHAM 2201R