2201R Mobile Tester SCPI Reference Guide
Chapter 10 Measurement commands
47090/323
Copyright © 2016 Aeroflex Limited. All rights reserved.
252
:MEASure:EGPRs[:CONTinuous]:RFTX:POWer
Syntax
:MEASure:EGPRs[:CONTinuous]:RFTX:POWer
Parameters
There are no parameters.
Description
Starts a continuous measurement of the mobile RF output power level. To read out the latest measurement result,
use the :FETCh:EGPRs:RFTX:POWer command.
Query
The query form of this command starts the measurement and returns a measurement result value as soon as the first
measurement has been completed. The string delivered back contains one floating point real number with the
physical dimension of dBm.
Example
:MEASure:EGPRs:CONTinuous:RFTX:POWer?
The string returned in this example is: "11.22".
:MEASure:EGPRs[:CONTinuous]:RFTX:TEMPlate
Syntax
:MEASure:EGPRs[:CONTinuous]:RFTX:TEMPlate
Parameters
There are no parameters.
Description
Starts a continuous check of the UL burst against the power-time template (PTT). To read out the latest measurement
result, use the :FETCh:EGPRs:RFTX:TEMPlate command.
The power-time template (PTT) is user-definable.
Note: The power-time template can also be set using the :CALC:RFTX:TEMP commands.
Query
The query form of this command starts the (continuous) check and returns a result value as soon as the first check
has been completed. The string delivered back contains one boolean number.
A 0 indicates that there was no violation of the PTT, while a 1 means that the last burst measured did violate the PTT.
Example
:MEASure:EGPRs:CONTinuous:RFTX:TEMPlate
This command starts the continuous check of the burst against the PTT.
To Next Page
Loading...
Need help?
General