2201R Mobile Tester SCPI Reference Guide
Chapter 6 Status commands
47090/323
Copyright © 2016 Aeroflex Limited. All rights reserved.
68
:STATus:OPERation:SIGNalling:GSM:CONDition?
Syntax
:STATus:OPERation:SIGNalling:GSM:CONDition?
Parameters
There are no parameters.
Description
This command reads out the current contents of the signaling operation condition register. This register reflects the
current state of the 2201R in terms of signaling and is updated continuously.
Note: This register is nondestructive. This means that it keeps its contents after any query.
Query
There is only a query form of this command available. The query returns a string, containing one integer. The integer
expresses all bits set in the 16-bit signaling operation condition register.
Note: Bits 14 and 15 (the MSB) of this register are not used. Therefore, the maximum value returned is "16383".
Example
:STATus:OPERation:SIGNalling:GSM:CONDition?
Value returned: "512".
This means that bit 9 has been set and that there is a change of the call channel currently in progress. Bit 9 is reset as
soon as the change of the call channel has been completed.
:STATus:OPERation:SIGNalling:GSM:ENABLe
Syntax
:STATus:OPERation:SIGNalling:GSM:ENABLe <int1>
Parameters
int1 is an integer. The minimum value for int1 is 0, the maximum value is 32767. The default value is 0.
Description
This command sets the enable filter of the signaling operation register group. This mask is ANDed with the signaling
operation event register and thus decides what kind of events are forwarded to bit 8 of the General operation register
group.
Query
There is no query form of this command available.
Example
:STATus:OPERation:SIGNalling:GSM:ENABle 16
This means that any setting of bit 4 (MS clearing) of the signaling operation event register raises bit 8 of the general
operation condition register.
To Next Page
Loading...
Need help?
General