2201R Mobile Tester SCPI Reference Guide
Chapter 11 Fetch commands
47090/323
Copyright © 2016 Aeroflex Limited. All rights reserved.
286
:FETCh:GPRS:MULTIslot:RFTX:PPEAk?
Syntax
:FETCh:GPRS:MULTIslot:RFTX:PPEAk?
Parameters
There are no parameters with this command.
Description
Only the query form of this command is available.
Query
Returns a string containing int1 times the result string from the :MEASure:GPRS:CONT:MULT:RFTX:PPEAk query. int1
is specified with the preceding :MEAS:GPRS:ARR:MULT:RFTX:PPEAk command.
Example
:CONF:GPRS:MSTA:MSL 2
:MEAS:GPRS:ARR:MULT:RFTX:PPEAk 3
:FETCh:GPRS:MULT:RFTX:PPEAk?
Returns a string containing nine results separated by commas, for example
2,8.3,9.6, 2,8.1,8.9, 2,8.2,9.5
:FETCh:GPRS:MULTIslot:RFTX:TEMPlate?
Syntax
:FETCh:GPRS:MULTIslot:RFTX:TEMPlate?
Parameters
There are no parameters with this command.
Description
Only the query form of this command is available.
Query
The return string contains int1 times the number of the uplink time slots followed by the pass/fail results for the
individual slots, one result for each slot. A 0 indicates that the burst shape is inside limits, 1 indicates outside limits
for the respective part. int1 is specified with the preceding :MEAS:GPRS:ARR:MULT:RFTX:TEMP command.
Example
:CONF:GPRS:MSTA:MSL 2
:MEAS:GPRS:ARR:MULT:RFTX:TEMP 3
:FETCh:GPRS:MULT:RFTX:TEMP?
Returns a string like the following:
2,0,0, 2,0,1, 2,0,1
In this example, the signal hits the limits in the second slot for the second and third measurement.
To Next Page
Loading...
Need help?
General