2201R Mobile Tester SCPI Reference Guide
Chapter 2 Remote control of the 2201R Mobile Tester
47090/323
Copyright © 2016 Aeroflex Limited. All rights reserved.
37
FETCh:LAST
The :FETCh:LAST? command reads out the latest result of the last MEASurement command issued - whatever
command that was.
Using this command, please keep in mind that your control program then has to take care of the number and format
of the measurement result values returned.
To convert a result string back into single measurement result values, please refer to section ’How to convert a result
string back into numeric variables’ on page33.
FETCh:BLOCkdata:...?
The commands with the :BLOCkdata command element are used to read out all the single measurement results
necessary to generate the result graphics.
FETCh<{:measProp}>
The :FETCH<{:measProp}> commands read out the latest result of the measurement specified with
measProp.
To Next Page
Loading...
Need help?
General