CTS FOS-3126-PLUS SERIES - Page 49

49
Switch(config)# ip igmp
snooping query-interval [1-6000]
secs
[1-6000]
Specify Query time interval. This is used to
set the time interval between transmitting
IGMP queries.
Switch(config)# ip igmp
snooping vlan [1-4094]
[1-4094]
Specify a VLAN ID. This enables IGMP
Snooping on a specified VLAN.
Switch(config)# ip igmp
snooping vlan [1-4094] query
[1-4094]
Enable a querier on the specified VLAN.
No command
Switch(config)# no ip igmp
snooping
Disable IGMP Snooping function.
Switch(config)# no ip igmp
snooping flooding
Disable flooding function. Traffic will
forward to router-ports only when disabled.
Switch(config)# no ip igmp
snooping immediate-leave
Disable IGMP immediate leave function.
Switch(config)# no ip igmp
snooping max-response-time
Reset maximum response time back to the
factory default.
Switch(config)# no ip igmp
snooping mcast-router [port_list]
[port_list]
Remove the selected ports from the router
port list.
Switch(config)# no ip igmp
snooping query-interval
Reset Query interval value back to the
factory default.
Switch(config)# no ip igmp
snooping vlan [1-4094]
[1-4094]
Disable IGMP Snooping on the specified
VLAN.
Switch(config)# no ip igmp
snooping vlan [1-4094] query
[1-4094]
Disable a querier on the specified VLAN.
Show command
Switch(config)#show ip igmp
snooping
Show current IGMP snooping status
including immediate leave function.
Switch(config)#show ip igmp
snooping groups
Show IGMP group table.
Switch(config)#show ip igmp
snooping status
Show IGMP Snooping status.
5. Configure IGMP Filtering policies.
IGMP Filtering command
Parameter
Description
Switch(config)# ip igmp filter
Enable IGMP Filtering function.
Switch(config)# ip igmp
segment [1-400]
[1-400]
Specify a segment ID.
Switch(config-segment-ID)#
name [segment_name]
[segment_name]
Specify a name for this segment.
Switch(config-segment-ID)#
range [E.F.G.H] [E.F.G.H]
[E.F.G.H]
[E.F.G.H]
Specify a multicast IP range.
Switch(config)# ip igmp profile
[profile_name]
[profile_name]
Specify a name for this profile.
Switch(config-profile-ID)#
segment [1-400]
[1-400]
Specify an existing segment ID.
No command
Switch(config)# no ip igmp filter
Disable IGMP Filtering function.
Switch(config)# no ip igmp
segment [1-400]
[1-400]
Delete the specified segment. Only
the segment that does not belong to
any profiles can be deleted.