Switch(config)# no ip igmp
profile [profile_name]
Delete the specified profile.
Switch(config)# show ip igmp
filter
Show IGMP Filtering setting.
Switch(config)# show ip igmp
filter interface [port_list]
Show the specified ports‟ IGMP
Filtering status.
Switch(config)#show ip igmp
profile
Show IP multicast profile information.
Switch(config)#show ip igmp
profile [profile_name]
Show the specified profile‟s setting.
Switch(config)#show ip igmp
segment
Show IP multicast segment
information.
Switch(config)#show ip igmp
segment [1-400]
Show the specified segment‟s setting.
Switch(config-segment-ID)#
show
Show the selected segment‟s setting.
Switch(config-profile-ID)# show
Show the selected profile‟s setting.
IGMP Filtering command example
Switch(config)# ip igmp filter
Enable IGMP Filtering function.
Switch(config)# ip igmp segment 50
Switch(config-segment-50)# name Silver
Specify a name “Silver” for this
segment 50.
Switch(config-segment-50)# range 224.10.0.2
229.10.0.1
Specify a multicast IP range
224.10.0.2 to 229.10.0.1.
Switch(config)# ip igmp profile Silverprofile
Specify a name “Silverprofile” for this
profile.
Switch(config-profile-Silverprofile)# segment 50
Silverprofile includes segment 50.
6. Use “Interface” command to configure a group of ports’ IGMP Filtering function.
Switch(config)# interface
[port_list]
Enter several discontinuous port
numbers separated by commas or a
range of ports with a hyphen. For
example:1,3 or 2-4
Switch(config-if-PORT-PORT)# ip
igmp filter
Enable IGMP Filter on the selected
ports.
Switch(config-if-PORT-PORT)# ip
igmp filter profile [profile_name]…
Assign the selected ports to a profile.
Switch(config-if-PORT-PORT)# ip
igmp max-groups [1-512]
Specify the maximum number of
multicast streams.
Switch(config-if-PORT-PORT)# ip
igmp static-multicast-ip [E.F.G.H]
vlan [1-4094]
Create a static multicast IP to VLAN
entry.
Specify static multicast IP address.
To Next Page
Loading...
Need help?
General
