Datalogic DS8110 - Page 151

E-GENIUS
139
4
Field Name
Action/Definition
Align Filler
Char
Click to activate the Text Entry Tool and create a filler character in the text field
provided. This filler is used to extend the Align Length.
Header
Click to activate the Text Entry Tool and create a Header in the text field provided.
Headers (up to 128 bytes) can be defined and transmitted as a block preceding the
barcode(s). Use characters from NUL (00H) to ~ (7EH).
Click Submit to save your text to the origin window text field, or click Cancel to return to
origin window without transferring text.
Terminator
Click to activate the Text Entry Tool and create a Terminator in the text field provided.
Terminators (up to 128 bytes) can be defined and transmitted as a block following the
barcode(s). Use characters from NUL (00H) to ~ (7EH).
Click Submit to save your text to the origin window text field, or click Cancel to return to
origin window without transferring text.
Message
Location
for Global No
Read
Select Only No Read Message, Before No Read Message, or After No Read Message
from the drop-down list.
Global Scale
Type (Units)
Select Metric (mm) or Imperial (0.1 in) from the drop-down list.
Code
Identifier
Select Disable, AIM, or Custom from the drop-down list. A Code Identifier string can be
included in the output message.
 If Disable is selected, no code identifier is included in the output message.
 If AIM is selected, the AIM standard identifier is included in the output message
 If Custom is selected, the Code Identifier Strings group is activated at the bottom of
the window, allowing you to define an identifier string for each code symbology. The
string will be included in the output message.
Code Identifier Strings
This section of the Message Format window is only available when Custom is selected as
the Code Identifier. Click to activate the Text Entry Tool and create a custom code
identifier string for any listed code symbology.
Click Submit to save your text to the origin window text field, or click Cancel to return to
origin window without transferring text.
3. When you have finished making changes, click Update All to save all pending changes,
click Reset All to revert to all previously saved values, and click Reset Page to revert to
previous saved values on the current page.
0.