Datalogic Matrix 300N - Page 200

Software Configuration
184 Matrix 300N
Slave Node Alarms (Master only):
X = slave node number (1-31)
R = Device Network Type – MUL=Multidata, SYN=Synchronized
Network State (Master only):
M = Master diagnostic condition; S = Slave diagnostic condition:
* = sca
nner OK
- =scanner not detected at startup
? =sca
nner detected at startup but not responding to diagnostic polling
! =
scanner diagnostic error
Standard Reading Results:
A = reading result – Good Read, Partial Read, Multiple Read
X = code content
Y = number of codes read
Reading Mask Only (Master Only):
X = code content (or "No Read" or "Multiple Read")
Y = Good Read, No Read, Multiple Read and Partial Read counters on the last 100
co
des read (%)
S = Reading Mask for Stand Alone or Master plus Slave readers 1 - 15
(0 = No Read, 1 = Good Read, M = Multiple Read)
T = Reading Mask for Slave readers 16 - 31
(0 = No Read, 1 = Good Read, M = Multiple Read)