Delphin ProfiMessage - 3.7 Installing internal memory card

ProfiMessage

l Tightenthescrewsevenlyinorder,anddonottightenonescrewafter
another.
3.7 Installing internal memory card
Electronic components are sensitive to ESD
(Electro-Static Discharge). Therefore, dis-
charge any electrostatic energy before opening
the device to install a memory card. We recom-
mend wearing an anti-static wrist band (static
discharge wrist band) and to carry out the
work on a conductive surface.
Removing and replacing the memory card
1. Disconnecttheunitfromthepowersupply.
2. Removeallconnectorsfromthedevicefront.Leavethecablesthatare
attachedtotheterminalsoftheterminalblocks.
3. Unscrewthefourlockingscrewsattheendsofthetwoterminalblocksuntil
adistinctcrackingsoundisheard.Thescrewshaveretainingringstopre-
ventthemfallingoutandhencedonotfullyunscrew.
39
Delphin Technology AG
Dezember 2015
ProfiMessage Manual