Delphin ProfiMessage - 9.3.1.2 I;O module status;measurement block counter; 9.3.1.3 Configuring;settings for an analogue input

ProfiMessage
Setsoneofthedigitaloranalogueinputsasthesourceformeasuringrotation
speedtowhichtheFFTanalysisisassigned.Keyword:Rotationspeedstampfor
frequencyspectrumandorderanalysis.
Digitalinput1or2shouldbeusedasthesettingwhenfrequencymeasurement
takesplaceviaoneoftheseinputs.
Redundancy mode
Tworotationspeedsensorsandtwodigitalinputscanbeoperatedtoachieve
redundancy.ReferheretoRedundanttriggersource.
9.3.1.2 I/Omodulestatus/measurementblockcounter
Measurementdataisrecorded,evaluatedandtransmittedaccordingtotheI/O
modulesettingsandtriggerevents.
TheDataServiceConfiguratorprogramdisplaysacounterforthenumberofrecor-
dedmeasurementdatablocks,asstatusinformationfortheAMDTI/Omodule.

9.3.1.3 Configuring/settingsforananalogueinput
Referalsotothetechnicalspecificationsforanalogueinputs.
Active
Activatingthischanneltransmitsthetimesignalasameasurementdatablockfol-
lowingeachtriggering.Unrequiredchannelsshouldbedeactivated.
Additionalsettingsforall“analogueinput”channelscanbefound
inthetimesignaltabfortheI/Omodule.RefertosectionCon-
figuration/settingsforI/Omodule.
Main settings tab
291
Delphin Technology AG
Dezember 2015
ProfiMessage Manual