Delphin ProfiMessage - Page 91

ProfiMessage
DigitaleingängealsZähler(Impulszählung)oderzurFrequenzmessung verwendet
werdensollen.Pulsecountingoccursaccordingtoasignal'sfallingedge.Forfre-
quencymeasurement,pulsesarecountedthatoccurwithinthegatetime.Theres-
ultisthenconvertedintoafrequency.
ReferalsotoModuleintheModule Settings tab,underMain settings.
Pulse counting or frequency measurement settings
apply to all digital inputs of an I/O module.

Theexamplemeans:0pulsescorrespondto0degrees,7200pulsescorrespond
to3600degrees(10rotations).
91
Delphin Technology AG
Dezember 2015
ProfiMessage Manual