Delta DVP-20PM

5 Applied Instructions and Basic Usage
Click Add Motion Control Function Blocks… on the context menu.
(2) The Add Function Block window appears.
Users can select motion control function blocks in the Add Function Block window. If the users click
Select All, all the motion control function blocks in the Add Function Block window will be selected.
After users select motion control function blocks, they have to click OK.
(3) After the users click OK, the motion control function blocks selected in the Add Function Block
window will be automatically added to Function Blocks in the system information area.

The folders added to Function Blocks are shown below.

Definitions of the folders
 SingleAxis: Uniaxial motion (Uniaxial point-to-point motion, electronic gear synchronization,
and electronic cam synchronization)
 MultiAxis: Multi-axis motion (G-code execution)
 Others: Other functions (measuring time, high-speed comparison, high-speed capture, and
setting interrupts)
DVP-20PM Application Manual
5-149