Delta DVP-20PM

5 Applied Instructions and Basic Usage
DVP-20PM Application Manual
5-257
 The device specified is C200 or C204.
mpSet: The value in the ter specified is cleared.
Rst: The counter specified counts.
3. Troubleshootin
McC
McCmp
coun
g
Error Troubleshooting
The values of input pins in the motion control funct
block are incorrect.
her
ranges allowed.
ion Check whet the values of the input pins are in the
The comparator specified has been used. er comparator. Use anoth
4. Modules which are supported
The motion control funct T pare
5.12.3 Resetting High-speed Compar
ion block _Com supports DVP20PM
ison
00D and DVP20PM00M.
1. Motion control function block
The motion con block T_CmpRst
CLRclr1, CLRY C20
rese valu ut pins
and C204 are e disabled.
2. Input pins/Output pins
trol function
2, CLRY3, CLR
es of the outp
nabled or
Out is used to reset
te whether the output de
high-speed comparison. CLRclr0,
ill be 0Rst, and CLRC204Rst determine the output devices which w
indicat. The vices CLR0, CLR1, Y2, Y3, C200,
Input pin
Name Name Name Name Name
Enable
ction
transition in the
signal from low to
high.
BOOL -
The motion
control fun
block is enabled
when there is a
Enable input pin’s
True/False
CLRclr0
CLRclr1
CLRY2
CLRY3
CLRC200Rst
CLRC204Rst
Resetting the
output devices
CLR0, CLR1, Y2,
Y3, C200, and
BOOL True/False
block is executed, the value
input pins are updated repeatedly.
C204
When the motion control function
s of these