5 Applied Instructions and Basic Usage
DVP-20PM Application Manual
5-232
5. Modules which are supported
The motion control function block T_RotaryCut supports DVP20PM00D and DVP20PM00M.
5.10.28 Flying Shear
1. Motion control function block
The motion control function block T_FlyingSaw is used to create a flying shear curve, and execute
electronic cam motion. Users can modify the length of a cutting by means of the MaterialSize input pin.
After the length of a cutting is modified, the new cam curve created will be executed in the second or
the third cam cycle.
Concept
SERVO
SERVO
20PM
CAM
X axis
Y axis
Jog
Encoder output
Cut Length
CAM
Jog
Cut Length
CAM
Jog
Cut Length
123
SyncOu
blade
4
To Next Page
Loading...
