Delta DVP-20PM

9 Electronic Cam
9.6.2.2 Creating an Electr
onic Cam Curve
In electronic cam design process, PMSoft creates electronic cam data by operating displacement data
to generate the velocity data and the acc data. However, in this case users need to control the velocity
between Slave and Master. To obtain the velocity, users can input the velocity data in the displacement
table for creating the velocity curve. After the velocity curve is created with displacement and acc curve,
export the velocity data by clicking “Export” and import the velocity data by clicking “Import Speed Data”,
so that the velocity relationship between Slave and Master can be obtained.
1. Set the max resolution as 200.
2. Input the velocity data in the displacement table.
Position 1: 100 degrees
Position 2: 200 degrees
Position 3: 300 degrees
Click “Draw” and the displacement data can be obtained as below.
DVP-20PM Application Manual
9-58