Delta DVP-20PM

9 Electronic Cam
sections, the number of data points left will be equally distributed to the sections.
The users have to set resolutions according to equipment’s requirements. The
higher the resolutions set are, the more smoothly the equipment used operates.
Besides, the size of the electronic cam data gotten is big if the resolutions set are
high.

After sections of a cam curve are created, users can click
Save
,
Load
,
Clear
,
Draw
,
OK
,
Cancel
, or
set the initial position of the slave axis.

Save
: Saving the data set in sections

Load
: Loading the data which was saved

Clear
: Clearing all the data in sections

Draw
: Compiling the data set in sections, and drawing the electronic cam data gotten on the
electronic cam chart created

OK
: Compiling the data set in sections, drawing the electronic cam data gotten on the electronic
cam chart created, and closing the
Data Setting
window

Cancel
: Closing the
Data Setting
window.

Initial Setting
: Setting the initial position of the slave axis
After the users click “Export” in the CAM Chart-0 window, the displacement chart, the velocity chart,
and the acceleration chart in the CAM Chart-0 window will be saved in the CAMData folder in the folder
in which PMSoft is installed. There are three files in the CAMData folder.
 <Folder in which PMSoft is installed>\CAMData\Data_S.txt: Displacement
 <Folder in which PMSoft is installed>\CAMData\Data_V.txt: Velocity
 <Folder in which PMSoft is installed>\CAMData\Data_A.txt: Acceleration
Data_S.txt, Data_V.txt, and Data_A.txt are shown below.
Displacement chart
Path: <Folder in which PMSoft is installed>\CAMData\Data_S.txt
Velocity chart
Path: <Folder in which PMSoft is installed>\CAMData\Data_V.txt
Acceleration chart
Path: <Folder in which PMSoft is installed>\CAMData\Data_A.txt
DVP-20PM Application Manual
9-22