10 Application of G-codes
Step 6: If the users want to stop the operation in DNC mode, click Cancel. G-codes will stop when
the executed rows equal to the received rows. If the users need to reset and download the
file again, stop O100 and activate O100 again. The step can be skipped if there is no need
for stopping the operation.
Step 7: When the G-code operation is completed, the executed rows will be the same as the
received rows in monitor table. In addition, the number of received rows also equals to the
number of rows displayed in PMGDL. Also, Ox0 stops automatically when the operation is
finished as below.
Step 8: If the users want to execute other G-codes, repeat the steps from step 4.
DVP-20PM Application Manual
10-8
To Next Page
Loading...
