Delta DVP-20PM

11 CANopen Communication Card

Setting an HMI
An HMI is used as a master. It is connected to two slaves. The IP address of the HMI and Ethernet
connections need to be set. The steps of creating the connection between the HMI and DVP-FPMC
are as follows.
1. Click Configuration… on the Options menu.
2. Click the Main tab, and then select DOP-B10E615 65536 Colors in the HMI Type drop-down
list box.
3. Click Communication Setting on the Options menu.
4. Click the Ethernet tab.
5. After users click , they have to type a link name in the Link Name box, and select Delta DVP
TCP/IP in the Controller drop-down list box.
DVP-20PM Application Manual
11-23