MAINTENANCE & FAULT FINDING
Problem Action
Unclear or non existent print out.
eak and air
. It is
air pressure
is out of
sure
int head.
Should this appear to be a periodic
by an unstable air
non
e contrast is
un settings'
s been
as low a
g material.
or when using
ibbon.
resistance
f print head. When
it is important
e value. Do so
hardware and
printer type.
le is incorrectly
e print
off when
rolling this.
t.
The air pressure is too w
regulation must be increased
important not to lower the
so much that the print head
contact with the counter pres
platen/roller as this can result in a more
rapid burn out off the pr
error, it can be caused
supply.
The contrast is too weak or
existent. Control that th
increasing step by step in 'r
until a satisfying quality ha
achieved. Always try and obtain a
satisfying print quality using
contrast as possible.
Incorrect ribbon on packagin
This is a common err
other ribbon than Domino r
Incorrect typing of print head
on change o
changing the print head
to type in a new resistanc
by going to settings, click
choose
The print head cab
installed after changing of th
head. Ensure all power is
cont
The print head is worn ou
Print does not stick to the material an
not resistant to soft scratching
eak and needs
the contrast.
d on
It is not uncommon for the printout to
be affected by heat or cold later in the
process after a complete print job.
Should an incorrect ribbon have been
used this will have a negative effect on
the print resistance.
d is The air pressure is too w
to be increased on the air regulator
(max. 5 bar)
Incorrect adjustment of
Incorrect ribbon is being use
packaging materiel
27864 Issue 1January 2008 (243)
To Next Page
Loading...
Need help?
General
