EDAN U60 - Body Mark Function

U60 Diagnostic Ultrasound System User Manual Operation
- 99 -
6.9. Body Mark Function
To add a body mark:
1. Press Body Mark, the system displays the Body Mark dialog box of current exam by default.
You can switch to other tabs by moving the trackball and pressing Set. The often-used body
marks are listed under each tab, and you can press More to enter the page of seldom-used
body marks and press Back to return to the page of often-used body marks.
2. Highlight a body mark in the Body Mark dialog box, and press Set to confirm the choice to
add the body mark. The selected body marks are displayed in the bottom left corner of the
screen.
3. After adding a body mark, use the trackball to move the position of the probe; and the
rotation function of Multi-function knob is automatically activated and the rotation light is on;
you can rotate this knob to adjust the probe scanning direction.
4. Press Set to complete adding the body mark.
NOTE:
In dual or quad split mode, you can add a body mark to the currently active window; if you
press or .to switch to another window, you can also add a body mark to the
window.
To move a body mark:
1. Move the cursor to a body mark that needs to be moved, and a rectangle appears around the
body mark;
2. Press Set and move the cursor to a new position;
3. Press Set to confirm the new position.
To delete a body mark:
Press Clear to delete all of the body marks at one time.
There are 150 types of body marks, and the Abd tab of system body mark library is shown below: