U60 Diagnostic Ultrasound System User Manual Obstetric Measurements and Calculations
- 124 -
3. The results are displayed in measurement result window.
4. To begin a new AC measurement, repeat steps 1 through 3. You can measure a maximum of
one group of data.
8.1.7. FL
To measure FL:
1. In the B-Obstetric measurement menu, roll the trackball to highlight the menu FL, press Set,
and move the cursor to image and display “+”.
2. Measure FL by the method of distance measurement.
Reference Section 6.5.1 Generic Measurements in B Mode.
3. The results are displayed in measurement result window.
4. To begin a new FL measurement, repeat steps 1 through 3. You can measure a maximum of
one group of data.
8.1.8. AFI
To measure AFI:
1. In the B-Obstetric measurement menu, roll the trackball to highlight the menu AFI, press Set,
and move the cursor to image and display “+”.
2. Measure four groups of AF by the method of distance measurement.
Reference Section 6.5.1Generic Measurements in B Mode.
3. The results, AF1, AF2, AF3, AF4, and AFI are displayed in measurement result window.
4. To begin a new AFI measurement, repeat steps 1 through 3. You can measure a maximum of
one group of data.
8.1.9. TAD
To measure TAD:
1. In the B-Obstetric measurement menu, roll the trackball to highlight the menu TAD, press Set,
and move the cursor to image and display “+”.
2. Measure TAD by the method of distance measurement.
To Next Page
Loading...
