U60 Diagnostic Ultrasound System User Manual Inspection and Maintenance
- 176 -
15.2. Cleaning and Disinfection
Use only the EDAN-approved substances and methods listed in this chapter to clean or disinfect
your equipment. Warranty does not cover damage caused by using unapproved substances or
methods.
Edan Instruments has validated the cleaning and disinfection instructions included in this User
Manual. It is the responsibility of the healthcare professional to ensure that the instructions are
followed so as to ensure adequate cleaning and disinfection.
General Points:
Keep your ultrasound system, cables and accessories free of dust and dirt. To prevent the device
from damage, please follow the procedure:
Use only recommended cleaning substances and disinfectants listed in this manual. Others
may cause damage (not covered by warranty), reduce product lifetime or cause safety
hazards.
Always dilute according to the manufacturer’s instructions.
Unless otherwise specified, do not immerse any part of the equipment or any accessories in
liquid.
Do not pour liquid onto the system.
Do not allow liquid to enter the case.
Never use abrasive material (such as steel wool or silver polish).
Inspect the monitor and reusable accessories after they are cleaned and disinfected.
CAUTION
If you spill liquid on the equipment, battery, or accessories, or they are accidentally
immersed in liquid, contact your service personnel or EDAN service engineer.
15.2.1. Transducer Cleaning and Disinfection
Transducers should be cleaned and/or disinfected as necessary or between use with a
recommended cleaner or disinfectant. Disconnect the transducer from the system prior to
cleaning and disinfecting.
To Next Page
Loading...
