U60 Diagnostic Ultrasound System User Manual System Control
- 26 -
Chapter 5 System Control
5.1. Powering On/Off Device
To power on the device
Before powering on this device, check as below:
1. Check the potential equalization conductor and make sure it is connected properly.
2. Check all the cables and make sure there is no scrape or crack.
3. Check the control panel and the monitor and make sure there is no crack.
4. Check the probe and the connection and make sure there is no scrape or crack.
5. Check the power socket and the switch and make sure there is no damage.
To power on:
1. Connect the device to a standard three-pin power supply socket via the power cable; Or
Use the battery as the power supply.
2. Press the power on/off key on the top left of the control panel, and a startup interface appears.
When you use the battery as the power supply, press and hold down the power on/off key to
switch on the device.
To Login
If Password Protection is enabled (see section 5.7.13), the system displays a Login dialog
when booting up the system. Select user name from the User Name drop-down list, then
enter password and click Login.
For emergency use, click on Emergency to log on directly without entering user name and
password.
NOTE:
1. When both Admin1 and Admin2 password are forgotten, please contact the
serviceman for the system password reset.
2. It is not suggested to use Emergency login under non-Emergency situation.
Please login the system with your account or switch to your account through the
Switch User function (See "To Switch Users" below) prior to image scanning.
3. Ensure the privacy of patient information and data created through Emergency
login. It is suggested to remove the patient exam data from the ultrasound system
after Emergency scanning for protecting patient data from being accessed by
unauthorized users.
To Next Page
Loading...
