U60 Diagnostic Ultrasound System User Manual System Control
- 27 -
To Switch Users
If Password Protection is enabled, switching users is allowed without restarting the system.
1. Press Power on/off key, and the system will display a confirmation dialog box.
2. Select User from the confirmation dialog box. A login information dialog box will be
displayed providing access to changing user.
3. Select another user from the User Name drop-down list and then enter password to login.
To shut down the device
1. Press the power on/off key on the top left of the control panel and the system displays a
confirm dialog box.
2. Select Yes to power off the system.
Or,
If the system breaks down, long press the power on/off key on the top left of the control panel to
shut down the system directly.
NOTE:
Please unplug the AC power cord from the power socket and disconnect the battery if the
device is to remain idle for a long time.
CAUTION
1. Do not unplug the power cord before switching off the system.
2. Wait approximately five seconds between powering the system off and then on again.
This allows the system to complete its shutdown process.
Standby mode
To place the system in standby mode:
Press the power on/off key and select Standby from the confirmation dialog box, the system goes
into the maximum power saving state: Standby Mode. But the archived patient information,
measurement and images will be kept.
To wake up the system from standby mode:
Press the power on/off key to come out of Standby Mode, the system resumes working
immediately.
To restart the device
If there is any trouble described as below, please press the power on/off key to switch off the
device and then press it again to restart the device.
To Next Page
Loading...
