U60 Diagnostic Ultrasound System User Manual Operation
- 107 -
NOTE:
1. When you are sending, deleting or renaming a file, do not connect or disconnect the
USB disk.
2. USB disk must be in FAT32 format, while hard disk must be in EXT2 format.
3. Do not use the USB disk for other uses, but only for this device. Otherwise,
the storage and the transmission function may not be stable.
4. We suggest that you use the USB disk or hard disk supplied or recommended by
EDAN.
To send files
1. Press File, and select File Manager in the file menu.
2. Select a desired drive from the Drive pull-down menu and press Set, point to the file or folder
that need to be sent and press Set.
3. Select a destination drive from the Destination pull-down menu. The destination drive
includes local disk, USB-disk, DVD drive or DICOM server (If DICOM function is
installed).
4. If the destination drive is DICOM server, press File Send to send the DICOM and CIN files
to DICOM server directly.
If the destination drive is local disk or USB-disk press File Send to open the File Send dialog
box, select a target folder on the left, or press New Folder to create a folder for storing files.
Press OK to send files to the target directory.
If the destination drive is DVD drive, press File Send to burn the selected files to DVD disk
directly.
To delete a file folder/file
1. Select a desired drive from the Drive pull-down menu and press Set.
2. Point to the file folder/file that needs to be deleted, and press Set.
3. Press Delete, and you will be prompted whether to delete the files.
4. Press Yes to delete the files, or No to give up.
To rename a file
1. Select a desired drive from the Drive pull-down menu and the file format, and then press Set.
2. Point to the file that needs to be renamed, and press Set.
3. Press Rename to open the Input new name for the file dialog box, enter a new file name
with the keyboard.
4. Press OK to rename the file, or Cancel to give up.
To Next Page
Loading...
