EPSON Stylus Pro 9000
Adjustments 111
VERSION
This function confirms the firmware version and DIP switch settings.
NOTE:There are two DIP switches on the Main Board for enabling
the firmware to adapt to possible mechanical design
changes. Their factory settings are OFF and OFF, and in this
position the LCD displays “Ver. DipSW 0x03.”
“Ver. Parameter Pnl” and “Ver. Parameter Moe” are not
needed for printer servicing.
CONTROL PANEL
This function allows you to check the operation of the control panel buttons,
LED indicators, and LCD panel.
"Key" check
The name of the button that is pressed appears. Press the [Pause] button
twice to exit the "Panel: Key" function.
"LCD" check
All dots turn on. If a dot is not on, the LCD is not working properly.
"LED" check
The LED indicators turn on in the following order and the name of the
indicator appears on the display: Power, Pause, Ink End (K, C, Lc, M, Lm,
and Y), Paper Out, Roll Auto Cut, Roll Cut Off, and Sheet.
[Paper Source]
[SelecType]
[Pause] returns you
to previous menu
Ver. Firm XXXXXX
Ver. Parameter Pnl XXX
Ver. Parameter Moe XXXX
Ver. DipSW 0x03
Ver. Main Rev XX
Ver. Panel Rev 01
ON: 0
OFF: 1
16 bit
hexadecimal
16 bit
hexadecimal
[SelecType]
[Enter]
[Paper Source]
All dots = ON
"XXXXXX" = name of pushed button
Panel: Key
Panel: LCD
Panel: Key Panel: LED XXXXXX
Panel: Key XXXXXX
"XXXXXX" = name of flashing LED
To Next Page
Loading...
Need help?
General