EPSON Stylus Pro 9000
Disassembly & Assembly 63
LOWER PAPER GUIDE REMOVAL
Preparation: Remove the Maintenance Cover as described in Maintenance
Cover Removal on page 58.
1. Remove the eight screws (CP(W2) M3x6) securing the Lower Paper
Guide.
Figure 4-11. Lower Paper Guide Screws
2. While supporting the Front Cover with your hands, lower the Lower Paper
Guide as shown below. You may find it helpful to move the Front Cover up
and down while removing the Lower Paper Guide.
Figure 4-12. Lower Paper Guide Removal
ADJUSTM ENT
REQUIRED
After reinstalling the Lower Paper Guide, you must perform
the Cutter Position Adjustment.
CP(W2) M3x6
When installing the Lower Paper Guide, push it all the way
up before tightening the screws; this is most likely the
correct position for the Guide in relation to the cutter blade.
However, you should also verify its position by performing
the Cutter Position Adjustment as described in Chapter 5.
Lower Paper Guide
To Next Page
Loading...
Need help?
General