EPSON Stylus Pro 9000
Appendix 162
Special paper
For special paper meeting the following requirements, the feeding
operation and print quality are optimized.
Use at normal room temperature:
59 to 77 °F (15 to 25 °C)
40 to 60% humidity
Paper feeding is normal until the rear edge of the paper separates
from the core. At the point where the rear edge is free, print quality
is not guaranteed.
Upper spindle 15.75 inches (last 400 mm) not guaranteed
Lower spindle 11.8 inches (last 300 mm) not guaranteed
For special paper meeting the following requirements, the feeding operation
and print quality are optimized:
* Print quality optimized when printing unidirectional printing.
7.2.10 Paper Release Lever
If the paper release lever is down, the feed path is open and you can load,
remove or change the position of paper in the feed path.
If the paper release lever is up, the feed path is closed and loaded paper is
locked in place. You can print on the loaded paper. It is not possible to change
the lever position during printing.
7.2.11 Interface
This section describes the interfaces for the EPSON Stylus Pro 9000.
Transmission mode
Based on RS-423
Synchronization
Synchronous
Transfer speed
About 1.8 Mbps
Data format
Start bit: 1 bit
Data bit: 8 bits
Parity bit: None
Stop bit: 1 bit
Table 7-3. Specifications for Special Paper
Paper Part Number Paper Size Roll Size
Presentation
matte paper
S041220 44 in. (1,118 mm) 2-inch core. Paper
thickness (radius) of 3.9
inches (100 mm) or less.
S041221 36 in. (914 mm)
Semi-gloss
photo paper
S041223 44 in. (1,118 mm)
S041222 36 in. (914 mm)
Photo paper
glossy
S041224 44 in. (1,118 mm)
S041225 36 in. (914 mm)
Table 7-4. Special Paper Specifications
Paper Dimensions (W x H) SuperFine* Glossy Film
A3 11.7
×
16.5 in.
(297
×
420 mm)
OK OK
2
A3 Wide 13
×
19 in.
(329
×
483 mm)
OK OK
A2 16.5
×
23.4 in.
(420
×
594 mm)
OK —
Table 7-5. Print Area and Margin Optimization for Roll Paper
To Optimize For. . . . . .Select This Setting
Largest printable area and decrease chance of paper
rubbing printheads
T/B15MM*
Exact paper size and decrease chance of paper rubbing
printheads
15MM
Largest printable area and exact paper size 3MM
To Next Page
Loading...
Need help?
General