Epson Stylus Pro 9000 - Print Engine User Manual

EPSON Stylus Pro 9000
Printer Basics 14
PRINTER SETTING MENU
The bold item is the default setting.
* The printed image is the same size as the printed image using the 0.12 inch (3 mm)
setting. However, the printer adds 0.47 inch (12 mm) of paper clearance (for a total
margin of 0.59 inch [15 mm]) to the top and bottom edges to make paper feeding
more stable and to prevent the paper from rubbing the printheads.
Paper Configuration Register paper thickness and drying time,
and select registered configurations
page 16
Cutter Replacement Replace the paper cutter blade
page 16
Head Alignment Align the printhead
page 16
Table 1-4. SelecType Menus (continued)
Menu Description For more
information
Table 1-5. Printer Setting Menu
Message Item Explanation
PLATEN GAP
AUTO
Adjusts the platen gap. Normally leave
set to AUTO.
THICK
PAGE LINE
ON
When AUTO CUT OFF is selected on
the control panel, this setting
determines whether a line for manual
cutting is printed
OFF
INTERFACE
AUTO
Determines which interface the printer
checks for data. AUTO continuously
checks all interfaces and is good for
normal use. MAC is the serial interface.
PARALLEL
MAC
OPTION
PARA. I/F
COMPAT*
Determines the data transfer rate when
using this interface. Normally leave set
to COMPAT*.
ECP
CODE PAGE
PC437
Character code setting. PC437 is for
expanded graphics. PC850 is for multi-
lingual.
PC850
ROLL MARG
T/B15MM*
Top and bottom margins are 0.59 in.
(15 mm). The left and right margins are
0.12 in. (3 mm).
15MM All margins are 0.59 in. (15 mm).
3MM All margins are 0.12 in. (3 mm).
INIT. PANEL EXEC. Initialize control panel setup values

Epson Stylus Pro 9000 - Print Engine Specifications

General

Brand	Epson
Model	Stylus Pro 9000 - Print Engine
Category	Printer
Language	English