EPSON Stylus Pro 9000
Appendix 146
7.1 Unpacking and Transporting the Printer
Follow these procedures for unpacking and transporting the printer:
To set up the printer for initial use, see
Unpacking and Assembly
on
page 147.
To prepare the printer for transportation, see
Repacking and
Transporting the Printer
on page 155.
7.1.1 The Packaging
The printer comes from the factory packed in a large box (printer body and
accessories), and is delivered with a smaller box on top (for the stand and
lower accessories). If possible, save the original packaging in case you need to
transport the printer in the future.
BEFORE OPENING THE LARGE & MEDIUM BOXES
See the figure below for the packing condition and contents.
Figure 7-1. The printer and parts shipped in boxes
7.1.2 Contents of the Packaging
See the following for the contents of the large and medium size boxes.
MEDIUM-SIZE BOX
Parts packed in the medium-size box are as follows.
Legs x 2 (one for left and right)
Leg connections x 2 (for connecting the right and left legs / one each for
top and bottom)
W ARNING
The Stylus Pro 9000 is very heavy (over 200 pounds,
including both printer and stand). Use at least 4 people to
assemble the printer or lift it onto or off of the stand.
To Next Page
Loading...
Need help?
General