Esser 8000C - Extension Module (Part No. 772421)

Fire Alarm Computer 8000C / M
Page 105
13 Extension module (Part no. 772421)
Three slots for micro modules are integrated on the extension module. Connections are available
for each micro module. The pin assignment of the eight screw terminals depends on the employed
type of micro module. The pin assignment of the connectors is described for each micro module in
Chapter Micro modules.
Up to two extension modules can be installed in a fire alarm control panel
FACP 8000M
in Slot
1+2 of the basic module for the connection of additional micro modules. This extension module
can only be used for the fire alarm control panel
FACP 8000M (not 8000C)
.
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Place 1
Extension module
Place 2
Place 3
V2
V1
X 22
X 23
X 24
X 6 X 5 X 4
Fig. 49: Position of the assemblies – Extension module 772419
V1
Common fire LED on – panel emergency function (e.g. CPU failure)
V2
LED on – CPU failure
Place 1
general micro module slot
(do not connect an essernet
®
micro module, see note below)
Place 2
general micro module slot
(do not connect an essernet
®
micro module, see note below)
Place 3
general micro module slot
(do not connect an essernet
®
micro module, see note below)
X22
terminal for micro module slot 1
X23
terminal for micro module slot 2
X24
terminal for micro module slot 3
X 4/5/6
Plug contact of Slot 1 or
Slot 2
of the basic module of the FACP 8000M (FACP 8000 C
not possible)
☞
If an essernet
®
micro module is installed in the FACP 8000C / M, this module can only be
operated in the
micro module slot of the basic module
. For the essernet
®
micro module,
it is necessary to adapt the connections on the basic module using the jumpers X11-14.
Extension modu
le