Fire Alarm Computer 8000C / M
Page 39
4.9 Lamp test
The Lamp test function is activated for approx. 10 seconds to check the optical displays.
Press Key
Test
Fig. 41: Lamp test start
♦ All optical displays (LED) of the operating panel and the single zone indicator unit (if installed)
illuminate.
♦ The display area of the alphanumeric display is completely darkened.
♦ The control panel buzzer sounds.
♦ The versions No. of the panel software is then shown on the display.
This function ends automatically after approx. 10 seconds!
Pressing the Test key again stops the lamp test before the expiry of 10 seconds!
Lamp test
To Next Page
Loading...
