Page 92
Fire Alarm Computer 8000C / M
10.7 DIL switch S5
On the FACP 8000C / M, this DIL switch has no function.
For fault-free operation, the DIL switch S5 must always be set to "OFF". The LED V42 must not
light up.
Switch position "OFF" required for FACP 8000C/M
10.8 Reset-Function
Pressing the RESET button S1 initiates a restart of the central unit. Alarm and fault messages are
reset, and all alarm groups and primary lines are activated.
A cold start of the central unit with the RESET pushbutton is only possible with the cover contact
open (central unit housing).
asic module
To Next Page
Loading...
