Esser 8000C - Switching on; Resetting a Primary Loop

Fire Alarm Computer 8000C / M
Page 161
25.1.1 Switching on / resetting a primary loop
Fig. 7: Switching on / resetting a primary loop
♦
Enter the number of the primary loop to be switched on and press the
Select
function key
♦
Enter the number of the desired function (1 = Switching on/reset) or select the menu options
Switching on/Reset
with the cursor keys and press the
Function
key
The primary loop is switched on and indicated on the display with a alphanumeric message.
Switching off a primary loop
♦
Enter the number of the primary loop to be switched off and press the
Select
function key
♦
Enter the number of the desired function (2 = Switching off) or select the menu options
Switching
off with the cursor keys and press the
Function
key
The primary loop is switched off and indicated on the display with a alphanumeric message. In the
switched off state of a primary loop, the yellow LED
Collective switch-off
lights in addition to the
display message. The displays and controls programmed in the Customer data of the fire alarm
control panel for the function Switch-off are activated.
!
When a primary loop is switched off, for example the 4-zone module or the analog loo
p
module, all detector zones and fire detectors connected to this module are also switche
d
off.
Switched off fire detectors will not signal an alarm in the case of an event !
Commissioning / Servicin
g
Primary loop / transfer route
Primary loop : 121
Escape
Function
1 Switch on / reset
2 Switch off
3 Test
4 Replace detector