Esser 8000C - Simulation of Control States

Page 168
Fire Alarm Computer 8000C / M
25.1.5 Simulation of control states
Under this menu point, the state of any control, such as relays or open collectors, can be
simulated for test purposes.
The simulation of control states in an essernet
®
network is impossible. The function pertains
exclusively to controls which are allocated to this fire alarm control panel and are programmed in
the customer data with a control zone number, such as:
♦
Relay or open collectors of the micro modules of these FACP 8000C / M
♦
Detector base outputs of intelligent fire detectors (Series 9100)
♦
Detector base outputs of intelligent fire detectors (Series 9200)
♦
Controls of esserbus transponders in the analog loop
With the simulation of a control state, all programmed displays and controls for this control and
state are activated or deactivated. (Observe customer data programming)
☞
For the master box controls (Control numbers 1 to 10), a simulation is impossible !
☞
Simulation of individual detectors or zones is not supported via communications
transponder 788615 of the 8010 releasing control system.
C
ommissioning / Servicing