Esser 8000C - Page 20

Page 20
Fire Alarm Computer 8000C / M
Installer
Operating actions for the specialised installer for service and maintenance
purposes. (Individual password code required, if a code has been
programmed.)
Time funct.
Entry of time/date and the switching times of the Delay/Verify function.
Escape
Termination of the current input prompt without storing or executing the
function.
Acknowledge
Acknowledge the selected menu point/operation.
Function
Confirmation of the execution of the previously selected function.
Rem. text
Query of the additional text display (Remote text) of other fire alarm control
panels in the essernet
®
network. If an event has been detected by a fire alarm
control panel in the essernet
®
, the additional text from the activated fire alarm
control panel can be displayed by the remote text function on another fire alarm
control panel.
Information and additional text
Info
Display of any programmed information text relating to the message in the
alphanumeric display. If information text exists, i.e. has been programmed for
this message, the menu point Info is displayed. If info text has not been
programmed, the menu point Info is not displayed.
Param/AT
Display of the additional text programmed for the current message or a
parameter. For a parameter, a works-programmed information text for the
current message in the alphanumeric display is shown. It is possible to switch
from additional text/parameter display using the function key. If additional text
has not been programmed, the menu point Add. text is not displayed.
☞
If information or additional text has been programmed for a message, the additional text
(Param/AT) is always displayed first. Pushing the function key during the display of the
additional text shows the information text.
Operation