Express Two Scene Preset User Manual, v.3.1 99
Copying cues
You may want to use a cue’s channel levels as the foundation for a new
cue, group or submaster.
53
Use the following procedure to perform a copy
operation. This copy may be performed either in Blind or in Stage.
To copy a cue to another cue in Stage, follow the procedure below. If
copying in Blind rather than in Stage, omit step 3 from this procedure.
53.
You cannot copy an effect cue to a group.
Keystrokes:
Actions:
1. Press [Stage].
Selects the Stage display
2. Press [Cue] [1].
Prompt reads:
Select cue number
To select cue type, press TYPE
3. Press [Go].
4. Press [Record].
Prompt reads:
To record cue, select number and
press ENTER
To cancel, press CLEAR
5. Press [2].
a
a. Press [Sub] or [Group] before the number in step 5 if you want
to copy a look from a cue to a submaster or a group.
Corner reads: Cue 2
6. Press [Enter].
Cue copy is complete. Channel levels
have been copied from cue 1 to cue 2.
You can now modify the new cue
To Next Page
Loading...
