Express Two Scene Preset User Manual, v.3.1 45
Dimmer check
The console’s dimmer check allows you to raise unparked dimmers to a
specified level on stage, one at a time.
20
Select the starting dimmer, set
it at a level and then use [+] to check consecutive dimmers. You may do
a dimmer check in any display except Patch and Park.
Perform a dimmer check with the following procedure.
20.
If a dimmer is parked, the Dimmer Check window displays a “Parked” message
and shows the level at which it is parked. The Dimmer Check does not change a
parked dimmer’s level on stage.
Keystrokes: Actions:
1. Press [Dim].
Prompt reads:
Enter dimmer number(s), then
press AT to select level
2. Press [1] to start dimmer
check with dimmer 1.
Keypad corner reads:
Dim 1
3. Press [At].
Prompt reads:
Select dimmer level
(Press FULL button for 100%)
4. Press [7][5] to set the
dimmer’s level at 75
percent. You may also
press [Full] or [Level] to set
the dimmer at 100 percent
or at the [Level] setting.
Prompt reads:
To unpatch dimmer for dimmer
check, press ENTER
5. Press [Enter].
Dimmer 1 is set at 75 percent
Dimmer Check window appears
Prompt reads:
Press [+] or [–] to step through
dimmers. Press [Clear] to cancel
dimmer check.
6. Press [+] to select dimmer
2. Repeat as necessary.
Press [Clear] to end
dimmer check.
a
a. If the dimmer is doubled, the dimmer check is performed on
dimmer A of the doubled dimmer first. Pressing [+] moves to
dimmer B of the doubled dimmer.
Dimmer 1 returns to zero, dimmer 2 is
set at 75 percent
To Next Page
Loading...
