Express Two Scene Preset User Manual, v.3.1 261
Manual crossfades
In a crossfade, you normally set the channel settings for one scene blind
(without affecting live settings) while the other is live. When you want to
change from one scene to another, you use the crossfaders to
simultaneously fade the live scene out and bring the next one up.
Follow these steps to create scenes and run a show using manual
crossfades:
Flash a scene
Press [A/B Clear] to flash scene A on stage. Press [A/B Back] to flash
scene B on stage.
Keystrokes: Action:
1. Pull the A fader all the way
toward you. Push the B
fader fully away from you.
The stage is dark. The scene fader
status display shows both scenes at
0%
2. Create scene A by setting
the top bank of channel
sliders at desired levels.
3. Slide fader A fully away
from you.
Scene A comes up on stage. The
scene fader status display shows
Scene A at 100% and Scene B at 0%
4. Without moving the fad-
ers, set the lower bank of
channel sliders at the
desired levels for scene B.
5. Pull both crossfaders
down simultaneously to
bring scene B up and fade
scene A out.
Scene A fades out and scene B
comes up on stage. The scene fader
status display shows Scene A at 0%
and Scene B at 100%
6. Now set the upper bank of
channel sliders to the
desired levels for the next
look you want on stage.
7. Push both crossfaders up
simultaneously to fade
scene B out and bring
scene A up.
Scene A comes up on stage. The
scene fader status display shows
Scene A at 100% and Scene B at 0%
8. Repeat steps 4 through 7
for each pair of scene
changes.
To Next Page
Loading...
