258 Chapter 23 Two scene preset
Setting the scene mode
The procedure for setting the scene mode differs for the Express 24/48
compared to that for the Express 48/96 and 72/144 models because the
bottom row of sliders on the 24/48 functions as either channel sliders or
submasters depending upon your choice.
Express 24/48
When changing the scene mode for this model, you are asked to choose
how you will use the bottom row of sliders. You cannot use submasters
in this model while in two scene mode.
Express 48/96 and 72/144
Follow these steps to put the console in two scene preset mode.
Keystrokes: Action:
1. Press [Setup] [1] [Enter].
Selects System Settings menu
2. Press [15] [Enter].
Prompt reads:
Select scene mode, then
press ENTER
(1 = Two scene, 2 = One scene
without subs, 3 = One scene
with subs)
3. Press [1] [Enter].
Enables two scene mode
Keystrokes: Action:
1. Press [Setup] [1] [Enter]. Selects System Settings menu
2. Press [15] [Enter]. Prompt reads:*
Select scene mode, then press
ENTER
(0 = One scene, 1 = Two scene)
3. Press [1] [Enter]. Enables two scene mode
To Next Page
Loading...
